Vicks SpeedRead Thermometer

Vicks SpeedRead Digital Thermometer Parts

What to Buy with Vicks SpeedRead Thermometer

• Techniche Coolpax Phase Change Cooling Brow Coolers Insert
• Sunmark Saline Nasal Spray
• Medline Plus Digital Wrist Blood Pressure Monitor

How to use Vicks Speedread Digital Thermometer?

1. TURNING THE UNIT ON

1. Turn the unit on by pressing the On/Off button
2. A beep will sound, and the display will flash Red/Yellow/Green for 1 second
3. Wait for the unit to get ready

 – The display will perform a self-test 
 – The display will show the last measurement for 2 seconds 
 – After about 5 seconds, the display will show it’s ready 

2. SELECTING A TEMPERATURE LOCATION

Oral Use

1. It is suggested to use a probe cover for Oral Use to prevent the spread of germs
2. Place the thermometer under the tongue. It is important to place the tip of the thermometer well under the tongue to get a good, accurate reading. (Fig. 5) Place the sensor tip in areas marked with “3”. Keep mouth closed and sit still to help ensure an accurate measurement
3. When the peak temperature is reached (usually 9 seconds), 5 beep signals will sound, and the “°F” or “°C” sign will stop flashing. The temperature is now ready to read and will not change when the thermometer is removed
4. Dispose of the used probe cover and wash the thermometer as recommended

Under-the-arm (Axillary) Use

This method is used for babies and young children

1. Wipe the underarm with a towel
2. Place the probe tip under the arm so the tip is touching the skin, and position your arm next to your body. With a young child, it is sometimes helpful to hug the child to keep their arm next to their body. This ensures that the room air does not affect the reading
3. When the peak temperature is reached (usually 11 seconds), 5 beep signals will sound, and the “°F” or “°C” sign will stop flashing. The temperature is now ready to read and will not change when the thermometer is removed
4. Wash the thermometer as recommended

 Note: This method produces a temperature 1° lower than a temperature taken orally

Rectal Use

1. Commonly used for babies, young children, or when it is difficult to take an oral or underarm temperature
2. Cover the thermometer’s tip with a probe cover and lubricate with a water-soluble jelly for easier insertion. Do not use petroleum jelly. Read the label of the lubricant to be sure you are using the right kind
3. Lay the patient on his/her side. If the patient is an infant, the proper position for a baby is to lay on its stomach with legs hanging down, either across your knees or at the edge of a bed or changing table. This positions the infant’s rectum for safe and easy insertion of the thermometer
4. Gently insert the tip of the thermometer NO MORE THAN 1/2 inch into the rectum. If you detect resistance, stop. Hold the thermometer in place during the measurement
5. When the peak temperature is reached (usually 10 seconds), 5 beep signals will sound, and the “°F” or “°C” sign will stop flashing. The temperature is now ready to read and will not change when the thermometer is removed
6. Dispose of the used probe cover and wash the thermometer as recommended

 Note: This method produces a temperature 1° higher than a temperature taken orally

Cleaning Instructions

• Clean the probe tip by washing it with soap and warm water or by disinfecting it with rubbing alcohol (70% isopropyl alcohol)
• Wipe dry with a soft cloth
• DO NOT BOIL OR CLEAN IN DISHWASHER
• Do not wash the unit with any thinner or chemical solvent

Precautions

• High, prolonged fever requires medical attention, especially for young children
• Do not allow children to take their temperatures unattended
• Do not allow children to walk or run during temperature-taking